photogcyn

Can't get FULL shed roof and I've tried all the settings

Recommended Posts

I have attached two pics of the small house I've designed where I can't get the shed roof to come out fully over the front.

 

To let you all know, I have set all the "correct" wall to either Full Gable on the main side walls and the bump-out's walls, and Shed Roof on the front walls.

 

I have also done this on the attic floor.

 

I've set the pitch to 2/12 and all the other roof settings are to 36".

 

What I'm aiming for here is a full shed roof with no bump ins, but to be full over the areas beside the front bump out.

 

Does anyone have a tip or know what I can do or what I'm doing wrong here? Thanks.

post-382-0-83516400-1414168185_thumb.jpg

post-382-0-49999000-1414168195_thumb.jpg

Share this post


Link to post
Share on other sites

You should have put your second post in this thread, instead of starting a new thread for the same problem.  Others might not look at both threads and see the full problem.

Share this post


Link to post
Share on other sites

Have you seen the TimberCab 550 from FabCab?

Share this post


Link to post
Share on other sites

Thanks, DavidJPotter!

 

Solver: My design is based on the TimberCab 550, but is a bit smaller and incorporates our current cabin as a base to build on to.

Share this post


Link to post
Share on other sites

Thanks for showing a pic of your successful results!!

  • Upvote 1

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now