sjorge79 Posted May 2, 2021 Share Posted May 2, 2021 Hello beautiful community! I have a question. I'm doing an as build. On the second floor where a 6:12 roof pitch meets a 48:12 is where I have a wall issue. I got the roof/ceiling part but how do we generate a sloped wall? Please see generated drawing. I'd like to draw it as is on picture. Any suggestions appreciated! :) TIA!! Link to comment Share on other sites More sharing options...
sjorge79 Posted May 2, 2021 Author Share Posted May 2, 2021 Thanks for the tip. I believe to have updated the signature. I'm using Home Designer Pro 2019. I still have not come across a video or a solution to my lil issue, Link to comment Share on other sites More sharing options...
Jo_Ann Posted May 2, 2021 Share Posted May 2, 2021 Follow the directions in this knowledge base article, and you will get the sloped wall. https://www.homedesignersoftware.com/support/article/KB-00904/creating-a-bonus-room-above-a-garage.html Link to comment Share on other sites More sharing options...
sjorge79 Posted May 2, 2021 Author Share Posted May 2, 2021 Thank you. It still didn't resolve the issue. Link to comment Share on other sites More sharing options...
solver Posted May 2, 2021 Share Posted May 2, 2021 Easier to troubleshoot with your plan file. Close Pro before you upload. Link to comment Share on other sites More sharing options...
Jo_Ann Posted May 2, 2021 Share Posted May 2, 2021 Really? Link to comment Share on other sites More sharing options...
DavidJPotter Posted May 2, 2021 Share Posted May 2, 2021 What you are showing in your posted image is not a sloped wall, rather it is the underside of a roof plane or planes. If the slope is wrong, then the roof pitch is also wrong or its baseline is too low or high. That is what is creating the coffered ceiling, not a wall. DJP 1 Link to comment Share on other sites More sharing options...
sjorge79 Posted May 2, 2021 Author Share Posted May 2, 2021 Yes, this is correct. As a mater of fact, it is the roof creating the slope in the software but it's not creating filling up the wall yet showing a void where it should be walled. This is where I need help with. Link to comment Share on other sites More sharing options...
sjorge79 Posted May 2, 2021 Author Share Posted May 2, 2021 Jo_Ann, thank you. Can you help me create the two slopes per the photo? If you see closer there's a 6:12 and a 48:12 before it flattens out at 8' ceiling. Perhaps a video would greatly help all of us in the community. Thank you all!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now