Countertops not stopping at partitions

[FlightDeck]

Hi folks, encountered an issue today with countertops crashing through cabinet partitions (and adjacent appliances).  For example the one shown in the image shows the countertop with 2-inch overhang sticking through the adjacent partition and into the refrigerator. 

 

 

I haven't noticed this issue before and recall the countertops always stopping nicely at partitions.

 

Any ideas what is causing this?

 

Thanks and regards,

KDJ

 

 

[solver]

If I remember correctly, I always need to turn off side overhangs, or this happens, and testing just now confirms this.

[FlightDeck]

Thanks, Eric.  I had to do the same.  And in cases where that wasn't appropriate, I had to use the custom countertop feature instead.  I checked some earlier models I made and it seems the countertop never stops at the partition.  I hadn't noticed before because my overhangs were smaller.

 

KDJ

[DavidJPotter]

The command is found in the Base cabinet Specification dialog - "Flat Sides" 

 

DJP

[FlightDeck]

Thanks, David.  Unfortunately it does both sides so if it's also an end cabinet you lose the needed overhang.  I used a custom countertop instead.  I'm just surprised that the software doesn't automatically clip countertops at partitions given how smartly it seems to handle other situations. 

[Kbird1]

it's a good one for the Suggestions forum ....