solver Posted December 13, 2014 Share Posted December 13, 2014 Image 2 shows the problem. Can this unfilled space be eliminated via a setting? Is this a bug? Link to comment Share on other sites More sharing options...
Kbird1 Posted December 13, 2014 Share Posted December 13, 2014 I haven't seen that before ,did you try rebuilding 3D (F12) or closing and reopening the plan ? I don't have 2015 either though so you might want to submit it to TS if you haven't figured it out yet. M. Link to comment Share on other sites More sharing options...
RobynKS Posted December 14, 2014 Share Posted December 14, 2014 Have you checked your rafter sizes over each roof area? Link to comment Share on other sites More sharing options...
DavidJPotter Posted December 14, 2014 Share Posted December 14, 2014 The way that command is programmed "Roof Cuts Wall at Bottom" the wall needs to be 'on top" of a roof plane to work properly. To do otherwise is to use the software in an unintended way (so you get unintended results when you do so). If you program a wall to be cut by a roof plane at its bottom, you make sure that the wall in question is on top or within the area of a roof plane only. That is the only purpose of that command. DJP Link to comment Share on other sites More sharing options...
solver Posted December 15, 2014 Author Share Posted December 15, 2014 @DJP This image shows the upper wall sitting on the main roof plane. Is this what your were referring to? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now