DapperDan 0 Posted June 26, 2020 Hi, Probably a dumb question... Is there a setting to toggle such that I can input the raised heel height in terms of top of top plate to the top of top chord, like in the attached image? Thanks! Share this post Link to post Share on other sites
solver 613 Posted June 26, 2020 29 minutes ago, DapperDan said: Is there a setting to toggle such that I can input the raised heel height in terms of top of top plate to the top of top chord Not that I know of. Really simple to take a cross section, measure and adjust. 1 Share this post Link to post Share on other sites
Rookie65 40 Posted June 26, 2020 You could read up on "Energy Heel Trusses" in the reference manual and see if that works for what you wish to achieve? 1 Share this post Link to post Share on other sites
DapperDan 0 Posted June 27, 2020 To create a truss that sits on the top plate with no raised heel, do I leave the default settings alone here? I ask because if I make them both zero the truss appears to be floating... Thanks! Share this post Link to post Share on other sites
solver 613 Posted June 27, 2020 The program will most of the time do the correct thing on its own. 1 Share this post Link to post Share on other sites