Window Not Cutting Through Wall

[CCarpenter]

Any thoughts as to why this window isn't cutting through the exterior sheathing and siding? All of the other windows in this model are fine. This window is in a space or room that is open to below so I suspect that has something to do with it. I've tried placing it in the plan and on the model...  Thank you!

[Rookie65]

If you have auto rebuild walls on, it could possibly be that there are a couple of layers of wall there, so it isn't cutting through just one layer. Without the plan file, it's just a guess, though it does happen.

[CCarpenter]

Ok, I'll check. If that doesn't work I'll upload the plan file. Thanks 

[CCarpenter]

So it seems to have something to do with the stairwell and designating the 2nd floor area as "open to below. When there is a floor or I designate it as "Hall" the window cuts through but when I label it "open to below" it doesn't. I can't upload the model because it is too large. 

[solver]

When windows or doors do this, it's usually because there are two walls in the same space -- something that sometimes happens with multi story structures. You should be able to select the walls in a 3D view and see this.

 

Did you try zipping the file?

 

You can also use Edit Area (All Floors) to cut out a section of the plan.