PLANsLLC123 Posted February 2, 2016 Share Posted February 2, 2016 Anyone inclined to help... Somehow the right side of my gable roof raised by 12" above the opposite side? Retracing my steps...the second floor originally projected from outside wall to outside wall. In the 'RV Parking Area' I made the second story 'Open to Below' in order to get the clearance I needed in the space. This is the only think I can think may have affected the raising of the outside of the gable wall...since the deleted floor was 12" and the gable raised by 12"...but it does not make since to me why this would cause the issue...nor did it help me trace fixing the issue. Any ideas? Any help is appreciated. Thanks Tim Garage-RV Floor Plan (2.2.16).plan Link to comment Share on other sites More sharing options...
DavidJPotter Posted February 2, 2016 Share Posted February 2, 2016 Do you want the open covered space to have a taller ceiling than the enclosed space? If so, what is the intended ceiling height of each space please? This is not obvious from your plan file. DJP Link to comment Share on other sites More sharing options...
PLANsLLC123 Posted February 2, 2016 Author Share Posted February 2, 2016 The open covered space is intended to be 13' -0" The enclosed garage is intended to be 10' -0" Link to comment Share on other sites More sharing options...
katalyst777 Posted February 2, 2016 Share Posted February 2, 2016 The Baseline Height of the left roof plane is set to 163 9/16". The Baseline Height of the right roof plane is set to 176 3/16". 176 3/16 inches - 163 9/16 inches = 12.62500 inches difference. You can open the right roof plane's Specification dialog, move the radio button to lock the Ridge Top Height, and set the Baseline to match that of the left roof plane, if they are supposed to start at the same height. Link to comment Share on other sites More sharing options...
PLANsLLC123 Posted February 2, 2016 Author Share Posted February 2, 2016 I tried that but it affected the pitch. Leaving the pitch at 6:12 is the preference. And...when I tried it, if I recall, it did not drop the bottom. Am I just not doing it correctly? Link to comment Share on other sites More sharing options...
PLANsLLC123 Posted February 2, 2016 Author Share Posted February 2, 2016 katalyst777, Aaahh...my mistake. It worked! Thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now