DCortes

Watch the video: https://www.chiefarchitect.com/videos/watch/323/creating-a-split-entry.html

Sounds like your working on a SAH Project if so email me.

Look at the training videos they are there to help you. https://www.chiefarchitect.com/videos/watch/5422/drawing-and-editing-walls.html

Did you just download them and not install them ? Right click on the file and click on Install.

Please fill out your signature. https://www.chiefarchitect.com/videos/watch/1530/drawing-a-flat-roof-with-center-drain-and-parapet-walls.html?playlist=95

It's easier to render an opinion if the plan file is uploaded.

Post the plan as it can be a number of things i.e. what you sent to the layout is larger than the sheet.

Well I must say its a good response Eric, because until you do read up on it and watch the videos and do the follow along with Mitch process then it will also answer other questions that you might have down the line. Its the only way to learn the software.

Just type the word REGISTER and a 6x10 wall register should show up as a selection.

It is to my understanding that those that you see when under RUGS its like a wall to wall paint job. If you do a camera view and select a room and then click on that oriental rug you will see your cursor change over to a spray can. If you then click on that floor while still in camera view you will see it paint the whole floor as that rug you chose under RUGS.

For others to better assist you please fill out your signature and post a copy of the plan.

Check your knowledge base to find out. https://www.homedesignersoftware.com/support/article/KB-00746/creating-a-coffered-ceiling-using-the-soffit-tool.html

Just like Rookie 65 said you can create a pony wall for the exterior and then change it to what ever you like. However some of the Homes Designer Software packages have limitations. So first off correct your signature block so it show what version of the software you are using and what package you have. This way it will assist others in responding to your post with assistance. Do a search in the knowledgebase and I'm pretty it will come it. Its all part of learning the software and its components.

I agree with Kat with the KB-00897, I had similar problems until I updated my video card. Never had a problem since.

What is it that you are trying to get done ?