Problems using transform/replicate to set an electrical panel into a wall

[MCCCcc]

I have used transform/replicate to move the electrical panel into a wood stud wall so as to be flush with the drywall. On my current job, I used transform/replicate, as usual, to place the panel where it should go and it worked great. After the electrical plan was complete I had to redraw the wall to correct an issue, so the old wall was over written with the new and the electrical panel was deleted. The new instantiation of the electrical panel would not transform/ replicate into the wall. Is there a setting that I'm missing that allows the panel to transform into the wall?

 

I can not use undo button as there have been too many operations between when the wall was places and the panel reinstalled.

 

Thanks,

Michael

[DavidJPotter]

Just select a new electrical panel symbol from your Library Browser and place it manually, transform-replicate is a valuable tool  but in  this case it is unnecessary.

 

DJP