PattyS68 Posted September 2, 2021 Share Posted September 2, 2021 Hello, I am wanting to send my framing to a layout page one wall at a time via back clipped camera, however when I chose this method my framing will not display. It does not matter what wall I am on and I have checked that my layers reference framing in wall definition. I have played with the layers turning them all off then only headers and wall framing back on. Still does not generate. The below clip is of my end wall with all layers turned on. I followed the suggestions in HD Knowledge Base as well. Perhaps I am overlooking something? Thank you! Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 @solver Good evening, Thank you for the reply. I am in plan and all my framing has been built. It shows in every view but the back clipped. Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 @solver I have these two layers turned on. Also tried it in a new plan with a basic square and it did the same thing? Will show everything but this view. Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 Here you are Pumphouse 10 x 10- 9.1.plan Link to comment Share on other sites More sharing options...
solver Posted September 2, 2021 Share Posted September 2, 2021 Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 @solver thank you for the video. ! Perhaps I am not placing my camera where it needs to go? Here is mine. Pumphouse 10 x 10- 9.1.plan Link to comment Share on other sites More sharing options...
solver Posted September 2, 2021 Share Posted September 2, 2021 Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 @solver I can't thank you enough! I see exactly what I was doing wrong. Have a wonderful evening! Link to comment Share on other sites More sharing options...
PattyS68 Posted September 2, 2021 Author Share Posted September 2, 2021 @solver Is there a way to show a back lipped foundation to roof clip for adding the insulation and wall assembly? If this is considered a new thread, I will post as one Link to comment Share on other sites More sharing options...
solver Posted September 2, 2021 Share Posted September 2, 2021 5 minutes ago, PattyS68 said: If this is considered a new thread, I will post as one Please do, and I'm not clear on what you are looking for. Do you have an image you could show? Like this? Link to comment Share on other sites More sharing options...
PattyS68 Posted September 3, 2021 Author Share Posted September 3, 2021 @solver yes posted new thread Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now