Sign in to follow this  
bob-rpm

removed wall portion leaves drywall gap

Recommended Posts

I'm trying to remove exterior wall in entryway to fit cathedral ceiling, but every method I've tried leaves the gap in the drywall as shown. I've tried adjusting polylines, puting in doorway opening to size, etc. Also I tried uploading the plan file but get an error 305. Using HD pro 2015.

post-1200-0-68914100-1417738322_thumb.jpg

Share this post


Link to post
Share on other sites

Really need the plan. Have you tried zipping it? Maybe cut it down so just the problem part is shown.

Share this post


Link to post
Share on other sites

The problem wall gets marked "Roof Cuts Wall at Bottom" -- image 1.

 

You then need to manually drag the two roof planes over the entry into the wall. They should snap in place. I needed to pull the right side back a bit at the top right corner -- image 2.

 

Does this do what you wanted?

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this