Timeless_16

Does someone have a guide of sorts to the break line tool?

Recommended Posts

Trying to create a curved bench in a shower. I tried using a slab and a soffit. I know I was able to do this fairly simply in HD Pro 18, I am trying a suggestion I seen on the forum and using the custom counter top, set it to 0" from bottom, and made it 24" tall but no matter what I can't figure out a way of rounding the edge off. 

Any suggestions or techniques would be appreciated. Just haven't fully dusted the rust of my HD PRO skills yet.

Capture.PNG

Share this post


Link to post
Share on other sites

Soffits don't curve, custom countertops and slabs do. Custom countertops accept moldings.

 

ht1.thumb.png.3d8bf61c5e6e929eaad63984efae6423.png

Share this post


Link to post
Share on other sites

That is kind of what I was wanting, tried countertop and slab, must not be clicking or doing the right thing. I'll try it again tomorrow.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now