Gable and Attic Wall Framing not showing

[ZZONNER 0]

In the Orthographic Framing view, the gable wall framing is not showing.  How do I keep some material layers from showing in this view as well?  I also have two small attic wall sections I cannot get to show up.  Any help?  I have attached the file.

Plans_4_Single_Slope_Entry_Slab_for_Contractor_Stairs_MBrm_1.plan

[solver 492]

22 minutes ago, ZZONNER said:

the gable wall framing is not showing

 

Unless you are manually modifying framing, you need to auto build framing -- maybe turn on auto build so it's always up to date.

 

24 minutes ago, ZZONNER said:

How do I keep some material layers from showing in this view as well?

 

Layer Display Options

 

24 minutes ago, ZZONNER said:

I also have two small attic wall sections I cannot get to show up.

 

I don't see a wall there, so there is nothing to not show up.

 

Go to the Attic and draw in 2 walls. See Roof Cuts Wall At Bottom.

[ZZONNER 0]

Thanks a ton.  You're the best.

[solver 492]

That plan is a bit of a mess. It looks like you brute forced things instead of allowing the program to do its job.

 

The roof will mostly auto build, for example.

 

 

 

[ZZONNER 0]

I know, brute force is an understatement.  It's my first project with Pro, and it's been a work in process, design / build with the wife.  Should I just delete all the roofs and let them auto build or should I just start over?  I think I can generate good enough plans for permit from what I have but would like it to be better.  Using Deck Plank for Tongue and Groove ceiling has proven to be a challenge at the hips and valley, its direction jumps around.  

[solver 492]

Is it a new build, or remodel? Building here in AZ?

 

I'd start over, and I'll suggest there is room for improvement. There is lots of wasted space. 

 

Here is an example of how the master bath might change.