Exterior wall height issue when using roof trusses

[wrcolclough]

Home Designer Pro 2022

File attached.

 

I developed a design for a two story house with a flat roof (well, almost flat - 1/4" in 12").

I did floor plans for both floors, and the foundation.

I then added roof trusses (just two initially, haven't yet replicated and spread out over entire roof).

When I first added the roof trusses everything was ok, and all my walls - interior and exterior - were the correct height and the trusses sat on top.

I went and did some other fine tuning and then noticed that my exterior walls were now up to just under the top cord.

I have tried everything I can think of but nothing drops them back down to the ceiling height.

I suspect it is something simple so humbly asking for help!

Cheers, Bob

 

PS  Also just noticed there are no rim joists showing.

CH Ext Wal Height (230124-1).plan

[solver]

10 minutes ago, wrcolclough said:

When I first added the roof trusses everything was ok, and all my walls - interior and exterior - were the correct height and the trusses sat on top.

 

How about your ceiling heights? Wall height reflects ceiling heights.

[wrcolclough]

All still set at 231 3/8", which is correct.

[wrcolclough]

Just found it - checked default wall height and it auto corrected.

Not sure hw it got unchecked, but at least now I know to watch for it.

Thanks!

 

[wrcolclough]

I'll start a new topic re my missing rim joists.