How to move dimension extension lines closer to their referenced feature??

[KResner]

Home Design Architectural: 23.3.0.81-OSX

MacBook Pro: Catalina 10.15.7 (19H1519)

 

Extension lines end points seem to vary from "close enough" to "not really close enough" (in my opinion) to the features they are referencing.

In example shown below, I have a manual end-to-end dimension and want the extension line end point (red circle) to be closer to the wall.

 

I did not see any way in dimension defaults, or by editing the created dimension, to do this.

Is it possible, if yes ... how?

 

Thanks!

 

 

[solver]

I believe only Pro lets you adjust these lines.

 

You could a CAD lines over the top, but that's a pain because there are no snaps to help locate them.

[KResner]

Hi Eric,

 

Thanks for the quick response and input. Agree, the CAD lines method is too much effort for purely cosmetic gains.

At some point when I've completed all I can in Architectural, I'll be upgrading to one of the full featured programs to finish it up.

Regards,

Ken

[solver]

38 minutes ago, KResner said:

At some point when I've completed all I can in Architectural, I'll be upgrading to one of the full featured programs to finish it up.

 

If you do plan on upgrading, I'd do it now so you can take advantage of the new/improved features now.