twnctyguy 0 Posted Tuesday at 08:55 PM Is it possible in Home Designer Pro to create walls and ceilings where the rafters and studs are exposed? (See attached photo.) I know how to simulate it with the soffit tool but was wondering if there is a particular protocol in "setings" that I'm just not understanding. I have spent the better part of the afternoon combing through Home Talk and videos, still haven't seen anything that addresses this specific question. Thanks. Share this post Link to post Share on other sites
solver 644 Posted Tuesday at 09:20 PM Think about what needs to change to do this -- what you need to remove. Walls are easy. Share this post Link to post Share on other sites
twnctyguy 0 Posted Tuesday at 10:03 PM Well, I'm assumed that if I removed the drywall on the ceiling and walls that that would do the trick. Instead I get a layer of OSB on the ceiling and a flat surface of fir on the walls. So, color me dumb...I'm stumped! Share this post Link to post Share on other sites
solver 644 Posted Tuesday at 10:16 PM 10 minutes ago, twnctyguy said: and a flat surface of fir on the walls Have you built wall and roof framing, and set them to display? 11 minutes ago, twnctyguy said: I get a layer of OSB on the ceiling That's the default -- you will need to change it to whatever you want. Share this post Link to post Share on other sites
twnctyguy 0 Posted Tuesday at 10:29 PM As always you are the "go to" guy...thank you! Share this post Link to post Share on other sites
