Elliot Posted September 10, 2019 Share Posted September 10, 2019 I am trying to draw just a bathroom plan. It isn't a whole house, just a bathroom. It measures about 163x93 interior floor dims with a partition wall separating two areas. the right wall will be 100" high and the left wall will be 118" high. I can create a plan and set the default value for ceiling for floor 1 at either the 100 or the 118. But I am trying to make one wall shorter than the other to create the sloped ceiling. Not working. The only info I found on adjusting one wall height was to look at it in doll house view and drag the top handle of the wall down or up. I tried that but that didn't create a ceiling , so then I tried to add a custom ceiling plane and I could not get that to work. There has to be an easier way. thanks Link to comment Share on other sites More sharing options...
solver Posted September 10, 2019 Share Posted September 10, 2019 19 minutes ago, Elliot said: There has to be an easier way. Put a roof on it. 20 minutes ago, Elliot said: then I tried to add a custom ceiling plane and I could not get that to work That should work too. What was the problem? Link to comment Share on other sites More sharing options...
solver Posted September 10, 2019 Share Posted September 10, 2019 Watch on YouTube: http://youtu.be/pm2LgGK2b1w?hd=1 Link to comment Share on other sites More sharing options...
Elliot Posted September 11, 2019 Author Share Posted September 11, 2019 Thanks so much. that's truly amazing that you would create a video and put it up on youtube today to help me with my question. I will watch it again and then apply the lesson. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now