rfcomm2k

How to change cabinet shapes

Recommended Posts

Cabinet set on a 45 degree angle to form an angled breakfast bar. Other cabinets on either side of it,

 

I can make this happen, but there is a lot of wasted space between the angled cabinet and the cabinets on either side of it. Would like to grab an edit handle to make the back corners of the angled cabinet meet the side cabinets.

 

Is this possible?

 

Share this post


Link to post
Share on other sites
49 minutes ago, rfcomm2k said:

Is this possible?

 

No.

 

 

Share this post


Link to post
Share on other sites

 

1 hour ago, rfcomm2k said:

Is this possible?

 

This is a weak point in the software. What I have done in the past to emulate such a condition is to make a cabinet about 3-4 inches thick to look like the 45% angle front, fill in the back with another cabinet a few inches thick to emulate the back. Then cover the thing with a custom counter top. It is the best that can be currently done in terms of appearances. It is easier if the cabinets so configured are backed by a half wall so a second or back cabinet is not required where the half wall supports an elevated bar top.

 

DJP

  • Upvote 1

Share this post


Link to post
Share on other sites

@ Kat, I actually tried to post it in Q&A, not sure how it ended where it is.

 

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now