rfcomm2k Posted March 29, 2017 Share Posted March 29, 2017 Cabinet set on a 45 degree angle to form an angled breakfast bar. Other cabinets on either side of it, I can make this happen, but there is a lot of wasted space between the angled cabinet and the cabinets on either side of it. Would like to grab an edit handle to make the back corners of the angled cabinet meet the side cabinets. Is this possible? Link to comment Share on other sites More sharing options...
katalyst777 Posted March 29, 2017 Share Posted March 29, 2017 You probably meant to post this in the Suggestions section and not the company's Sales forum. Link to comment Share on other sites More sharing options...
solver Posted March 29, 2017 Share Posted March 29, 2017 49 minutes ago, rfcomm2k said: Is this possible? No. Link to comment Share on other sites More sharing options...
DavidJPotter Posted March 29, 2017 Share Posted March 29, 2017 1 hour ago, rfcomm2k said: Is this possible? This is a weak point in the software. What I have done in the past to emulate such a condition is to make a cabinet about 3-4 inches thick to look like the 45% angle front, fill in the back with another cabinet a few inches thick to emulate the back. Then cover the thing with a custom counter top. It is the best that can be currently done in terms of appearances. It is easier if the cabinets so configured are backed by a half wall so a second or back cabinet is not required where the half wall supports an elevated bar top. DJP 1 Link to comment Share on other sites More sharing options...
rfcomm2k Posted March 30, 2017 Author Share Posted March 30, 2017 @ Kat, I actually tried to post it in Q&A, not sure how it ended where it is. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now