Dominant wall external material at corner

[moreauj]

I have walls with different exterior finishes that meet at corners.

How can I control which walls exterior finish dominates the end of the wall.

For example; I have an 8" concrete side wall with a 8" front wall with stone facing.

The first 8" of the front wall inherits the concrete of the 8" side wall instead of the front wall stone exterior.

In the corner the side wall is "dominate" and "subjugates" the front wall.

I want the opposite situation with the front wall dominate.

Alternatively, instead of just setting the exterior material on the front wall, I added a 2" stone layer on the exterior of the 8' concrete wall type.

The side wall still blows through the front wall and i get the side of the side wall in concrete showing through to the front.

The only work around I've found is to put a break in the side wall to create a little stub wall and changed it to the front wall type.

However the stub wall has a minimum length of 15" of length so quite a bit of stone facing shows on the side wall which is not-representative.

Any suggestions?

[Rookie65]

Try opening the wall, go to structure. There should be an option to extend the wall through the start or the end. I don't remember if that version showed which was the start or end 

[moreauj]

Thank you Keith, you were spot on.

Now I know what those do!