Impossible to select a stair object that I had earlier inserted into my design

[lawrencelam2000]

Very odd...I earlier inserted a stair object into a small room on my plan, and now I'd like to work further with it, but I cannot select it with my cursor. I tried "select next object" in a dialogue that appeared, but no luck with that, either. What am I not doing right?

 

Update: please disregard; I just figured it out- the stair is in the basement 0 level, not on the first floor level 1. Apparently I had the 0 level set to "visible", so it was only an image when I was active on the first floor Level 1. (Sorry, I'm new to CA! Still learning my way around.)

[Jo_Ann]

Assuming you drew the stairs on floor 1, that is the floor that will allow you to select the stairs.