Knee wall connected to full wall - flush mounting

[jdavis37]

I hope my post will make sense especially given I am not a Home designer expert. I have managed to draw my room reasonably accurately and it models nicely in 3D. One one outer wall there are 3 windows (the bottoms of which are approximately 52 inches from the floor). Directly below those windows is a knee wall of sorts. The knee wall is 51 inches high and protrudes 6 inches inward from the outer wall with windows. In other words, we have a 6 inch wide ledge in the room below the 3 windows

 

This is the view:

 

 

I am trying to flush mount a panel above the knee wall attached to the upper wall. However, the way I have set things up the software thinks the knee wall extends the full height and refuses to let me flush mount a panel to the wall with the windows:

 

 

 

 

Changing camera view you can see the panel is acting like it is flush mounted to the knee wall as if the knee wall actually extended to the ceiling:

 

 

 

 

The panel should be flush against the wall just above the knee wall. Hopefully this is just a simple duh huh error on my part and can easily be remedied.

 

Thanks in advance

[jdavis37]

Thanks! That works. Little tedious and gosh only knows where that solution is thought out, but it does work and will let me move forward. Thanks a lot.. I had already beat my head bloody trying to figure out what I was doing wrong!