ca3762 0 Posted June 13, 2014 I have to deign a deck that has an existing tree in the middle. So I was wondering if someone know how to cut out an area of the deck where the tree is. so I build a let say square deck 20' x 20' and now I want to cut out a 4'x4' area where the tree is. how is this done? Share this post Link to post Share on other sites
Kbird1 159 Posted June 13, 2014 using invisible walls is one way , make a small 4'x4' room in the middle of the deck from invisible walls , connect those 4 walls to the deck railing if needed ( version 10 and before ,see image), set the room spec. to "open below" and turn off ceilings and roofs for the room too. On each invisible wall's DBX >general tab> check the box "Railing" as well .so you don't see drywall in the hole. One of the Deck tools may work similar , have a look on the KB for tutorials about Hot-tubs too. Mick. Share this post Link to post Share on other sites