matt554 Posted October 9, 2016 Share Posted October 9, 2016 It is probably a simple solution, but I have not had any success in searching for it in the knowledge base or on the forum. I have laid out the a simple first floor with two main areas, kitchen and living room. The walls were put up first then the pass through was added and I had now problems initially defining each area. The problem is at some point playing with room dimensions etc. both rooms are now the same object and I cannot find a way to reset or remove the object definitions so I can redefine them accordingly. Thanks Matt Link to comment Share on other sites More sharing options...
matt554 Posted October 9, 2016 Author Share Posted October 9, 2016 Never mind, found the issue. I had to remove a section of wall to add a fireplace that sits between both rooms, forgetting that this opened up the room definition. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now