HowdyYall

Greetings, I learned to use the manual roof tools to throw in elements that just didn't work with the automatic process. I can make it look ok on the elevations by adjusting it bit by bit, but the roof plan is a bit messy. How could I get these lines to align? Of course, I tried to make them line up, but that lead to the roof not lining up in the elevations. As you can see, the pitches are 12/12 and 9/12. I don't know if that enters into the equation.

Howdy, I am redrawing a plan my family has built many times that is actually named after us. I have most of it working out, except I need to add a gable that doesn't work automatically. Here is what I am looking at. Running HDPro 2021. Also, while I am asking, how can I get the dormer on the left side to pop up while all the rest of the roof is sitting on the top plate of the first floor wall?

Oh, thanks! Remarkably helpful. Thanks again. :-)

Good suggestion re: signature. Any thoughts on grade beams?

Simple question, I think, but I have been trying to figure out how to do this for over an hour so far: with a monolithic slab with footings around the exterior and grade beams under load bearing interior walls, how do I make the foundation plan reflect the load bearing interior walls? Do I have to just draw foundation walls under the 1st floor reference or can I make individual walls "foundation walls", which will show up in the right places on the foundation plan. I have tried both ways and neither seems quite right. The former shows up on the foundation plan, but I am not sure if is centered correctly, and the latter doesn't show up at all on the foundation plan. This would be very useful to the way I read plans when I build houses. Thanks, Tyler <>< Running HDPro 2021.