RNDesign
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by RNDesign
-
-
-
How would you create a triangular hearth and fireplace in home designer pro? I have a corner fireplace with a triangular shaped hearth that touches adjacent walls at a 45 degree angle. I've tried soffit and geometric shapes from the core library but cannot seem to figure out how to rotate an object about an x or y axis.
Shan
Home Designer Pro 2021
Mac OS Catalina 10.15.6
-
Thank you!
-
Thank you, David. I appreciate the advice. However, when I create the soffit, set its width and height and stretch it out from the edge of the wall to under the ridge of the roof, the option "place under ceiling" becomes grayed out. It is only active when the soffit is under the flat section of ceiling. Any ideas?
-
-
4 hours ago, solver said:
Someone will need your plan file to understand why it's happening. Close the software before attaching.
Thank you for the helpful info. I've attached the file.
-
I am creating a second floor nook above the kitchen open on one side. The ceiling above is sloped and I notice the room divider creates a gap in the ceiling the same width as the wall underneath and slices out the small section of the ceiling above. Is there a way to prevent this so that I can see the full uninterrupted ceiling?
Creating a custom kitchen hood in Home Designer Pro
in Q&A
Posted
How would I create a custom kitchen hood as seen below in Home Designer pro 2021? I've tried drawing the profile of the object but there is no way that I can see to create a poly line object. I believe there is a way to do it in chief architect by importing an object created in CAD into the library and then reimporting it, but Home Designer Pro will not allow me to do this. Any way around this?
Shan