JohnEisenbraun

Just for clarity, here is the example plan I used to illustrate the problem in the original post.

Keith, yes, I could do that, but that isn't correct. The roof on the one side of the house is made up of 3 sections, all on the same plane. Two of the sections are 2X6s, One is 2X8s. (See the original sample roof I drew). You can see three sections of roof. (There is a line in the shingles where the roof sections are drawn). Drawing the roof all with 2X8s also runs into the rafter tail issue I show above. I've attached the actual plan. Only the Foyer has 2X8s. The rest of the roof on that side is 2X6s.

Also, changing to 2X8s results in the following. I was hoping I could change a section of the roof (just the rafter tails area back to 2X6s), but that runs into the issue where I can't join roof sections again.

Keith, no, that isn't what I'm trying to do. Changing the entire roof plane to 2X8s would work, but that doesn't model the existing house. Only the section of the roof where the vaulted ceiling is has 2X8s. The rest of the roof is 2X6s.

If I try extending the 2X6s to 2X8s they show through the vaulted ceiling. Any way to fix that?

Just to clarify only the section with the skylight is 2X8s. The rest of the roof is 2X6s.

I'm not sure what you are telling me... I've uploaded another picture. It shows the original problem a little better. I can't join the three sections of roof that make up the roof. Home Designer won't let me. I can try changing each individual rafter (in the 3d rafter view) that are in the vaulted ceiling to 2X8's - that might work. I did have an issue when I change the entire roof to 2X8s where the rafter tails jut out from the facia. (In the actual house, the rafter tails are cut down to 2X6 size which I don't think I can do in Home Designer.) I also tried to just create a ceiling plane the right thickness to make up the extra room for the 2X8, but the holes in the ceiling plane and roof don't align.

I am modeling my current house in anticipation of some remodeling. I have a vaulted ceiling (with a skylight) that has a different rafter size (2X8) than the other sections of the roof in the house (2X6), but is in the same plane as other roof sections. I have attempted to model this by creating different roof planes and then joining them, but that doesn't work. (Sample model attached.) I can't join the roofs. I can place the roof sections adjacent to each other, but they won't join which is functionally correct but doesn't look good in the 3d view. Is there any way to do this? Any alternate approaches? (I tried to upload my plan but I get an error -200.)