Dave_n_Deb

@solver Thank you! That is the direction I was thinking I would have to head...just wanted to ensure I wasn't missing something in the program. Appreciate your time. Dave

I am attempting to use a 3-way switch at top and bottom of stairs for the common stairwell light. Obviously, the light only appears on the 1st floor (Level 1) and not in the basement (Level 0), so I can only show the 3-way at the top of the stairs connected to the light; unable to show the 3-way switch at the bottom of the stairwell connected to the stairwell light on Level 1. Is it possible to show both switches connected? Or do I just have to install a 3-way in Level 0, but cannot connect it (shown) going to the light. I am using Home Designer Pro 2024. Similarly, I have a configuration where I built a second floor open to the 1st floor (basically a 5' lift to the living room). I have a ceiling fan hanging, but the switch needs to be on the first floor (Level 1), and I would like to show it connected to the ceiling fan, which physically resides on the 2nd floor (Level 2). Again, is this even possible? (Understand, in this case I may have created my own problem, maybe should have lifted the ceiling for that space in a different manner :-( Always learning! ) Thank you! D-n-D

@DavidJPotter The first suspect definitely doesn't apply, as I have used nothing from outside Home Designer Pro. The second suspect, I don't think so, but not sure how to determine ...unless it is due to the textures (lots of stone and wood) that I am using. As far as plan design, my rooms are square/straight (walls, ceilings, cabinets, roofs, etc). I thank you for your informational response!! I will use this information to more thoroughly investigate my issue. First project with this program....so learning a lot as I go. Thank you again, Dave

I am looking for possible reasons that my Surface Count would be excessive...if when I turn off all but essential Layer Display Options. The lowest I have been able to achieve is 1279420 Surfaces. Which is also driving my Texture Size well over 100 MB. Any assistance/suggestions would be greatly appreciated. Thank you, Dave