tspear
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by tspear
-
-
Hello,
I somehow managed to hide or delete the living area calculated field which appears on the bottom of the plan for one specific floor.
I have no value displayed. How do I restore it?
Tim
-
The top of the stairs fail to connect to the 1st floor. If you right click on the stairs and select auto connection you get an error message.
I eventually figured the issue out. Yes, I had the terrain defined incorrectly.
I used a terrain region and set it as the floor for the lower patio. After watching a few videos on pools, I eventually figured out I need to instead use the terrain feature, and set the height to the -96; e.g. the floor of the basement patio.
Now just to figure out why it is complaining about my knee wall and why my retaining walls do not extend downward.
-
The stairs do not "connect" to the from the walkout basement patio to the first floor patio.
Tim
-
Hello,
Using Home Designer Suite 2021.
I am not sure I did the terrain correctly, and as a result I am having problems connecting stairs from a patio on the first floor to a patio on a walkout basement.
Key points:
- The home site is a flat area on the crest of a steep hill
- The house will be set back about six feet from the edge of the hill
- Retaining walls will extend from the house to cut out the hill, allowing for a basement walkout onto a lower level patio.
Any pointers would be appreciated.
-
Eric,
I found it, but it was not obvious. It was caused by bad roof settings on the patio using a "Dutch Gable".
I think I will put this in as a feature request to be able to go to the object that "created": the auto generated feature..
Tim
-
1 minute ago, solver said:
Auto attic walls are created above a wall below. Have you tried deleting the wall?
Eric,
I delete the wall, it effectively makes it invisible. I delete the invisible wall and it redraws the wall.
There is no wall underneath it.
Tim
-
Home Designer Suite 2021
I have a wall which is offset about 5 ft from my exterior wall which is auto generated in the attic.
I cannot find what element is causing this wall to be magically generated in the air for the attic. (I do have a patio with a roof over it, but the patio is much larger than 5ft.)
How do I track the cause down of the auto generated wall section?
Thanks,
Living Area Calc Display
in Q&A
Posted
I knew it was simple. I just could not find it!
Thanks,
Tim