cpatullo
-
Posts
12 -
Joined
-
Last visited
-
Got it. Thank you Solver and Jo_Ann!
-
Correct
-
The wall to the left of the stairway - the blue wall. Currently, the stairs are only the width as shown - do I need the stairs to extend to the left (to the extent of the outer edge of the existing wall) and then create the railing wall?
-
Dumb question. If I am doing a railing wall/half wall, do I extend the width of the staircase out to what the wall would be on the room side of the wall (not the staircase side)?
-
I'm sorry. Thank you.
-
OK, I think I see my problem now. With the 'follow stairs', it will put the wall at a height that followed the railing. What if the wall height was only to be 6" above the tread, not the 32-36" that a railing would be at?
-
Looks like I need an upgraded version...I cannot do either. Bummer. Architech is a bit of a letdown...
-
Solver - how did you do this? I didn't get around to working on this until just now - I apologize for the delay...
-
I'm looking at this as well, JoAnn. Thank you!
-
Yes, that is what I want to do.
-
Solver- Thank you for the reply. No, I don't have the 'follow stairs' option on the wall. I built the wall in question as a wall...should I have built as a railing and modify? I will also take a look at the library.
-
Greetings all. I'm fairly new to HD. Using HD Architect 2017. I'm trying to make a triangular opening on one side of the stairs, opening into a room in the basement. From what I see, Pro has an easier way of accomplishing this, but I obviously do not have Pro. So, is there a way to get this done in Architect? In the attached picture, the opening would be on the right side, leaving a bit of a short wall to prevent small children from jumping off. Any help would be greatly appreciated.