Missing Section of Gable


MatthewM
 Share

Recommended Posts

Creating a cathedral ceiling (in the room below the missing section of gable), seems to cause a section of the gable to go missing. Any help? Is there a different tactic for creating the cathedral ceiling? What would be the way to correct this?

Design Problem 1a.PNG

Design Problem 1b.PNG

Link to comment
Share on other sites

You should be able to go to the attic floor and extend the wall over the room. Or try taking the ceiling plane line and bringing it all the way to the wall where the window is. This has been asked about many times, so there are likely previous posts about it that you can search for under keywords.

Link to comment
Share on other sites

Scott, I’ve had this happen a lot when you have auto rebuild roofs on and mark the one room no flat ceiling. You can drag the attic wall over and cover it up but then it hangs down in the room so you have to adjust the bottom of the wall also. 

Link to comment
Share on other sites

4 minutes ago, Garybills said:

Scott, I’ve had this happen a lot when you have auto rebuild roofs on and mark the one room no flat ceiling. You can drag the attic wall over and cover it up but then it hangs down in the room so you have to adjust the bottom of the wall also. 

There was a post on May 2nd with a similar issue, no good results other than manually extended the gable wall. 

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share