Can't get FULL shed roof and I've tried all the settings

[photogcyn]

I have attached two pics of the small house I've designed where I can't get the shed roof to come out fully over the front.

 

To let you all know, I have set all the "correct" wall to either Full Gable on the main side walls and the bump-out's walls, and Shed Roof on the front walls.

 

I have also done this on the attic floor.

 

I've set the pitch to 2/12 and all the other roof settings are to 36".

 

What I'm aiming for here is a full shed roof with no bump ins, but to be full over the areas beside the front bump out.

 

Does anyone have a tip or know what I can do or what I'm doing wrong here? Thanks.

[Jo_Ann]

You should have put your second post in this thread, instead of starting a new thread for the same problem.  Others might not look at both threads and see the full problem.

[solver]

Have you seen the TimberCab 550 from FabCab?

[DavidJPotter]

I like your design, very well done!

 

DJP

[photogcyn]

Thanks, DavidJPotter!

 

Solver: My design is based on the TimberCab 550, but is a bit smaller and incorporates our current cabin as a base to build on to.

[photogcyn]

Thanks, Jo_Ann.

Here's a pic of problem solved:

 

[Jo_Ann]

Thanks for showing a pic of your successful results!!