Exterior pattern not filling under eave

[Daddiosbullitt]

My apologies, I'm sure this has been covered before but I'm not even sure what to search for. I'm new to HD Pro so this is a great place for info. Thanks to everyone who contributes. As you can see the pattern for the brick does not fill under the eave.

[solver]

I imagine you need to pull the roof plane back from the wall.

 

If that does not work, post the plan file and someone will have a look.

[Daddiosbullitt]

Thank you sir! That definitely helped but as you can see a small part still doesn't fill in. I'm guessing because of the different ceiling heights? I attached the plan file as you suggested. I appreciate any help.

FINDLEY.layout

[solver]

Always post the .plan file. Layouts don't help.

 

If there is a wall there, it looks like an interior wall. 

 

Read up on Lower Wall Type When Split by Butting Roof. This gives you the ability to have one wall type above the roof, and one below.

 

[DavidJPotter]

The exterior wall seen in your image stops at the intersection of a perpendicular exterior wall, the reveal that shows is the edge of an interior wall at that intersection (a common occurrence) you can cover the interior wall reveal with a thin soffit or perhaps a custom slab if you like. Repairing such an occurrence using walls is unnecessarily complex and not recommended.

 

DJP

[LawB10]

Use the inverted wedge....