Monitor barn roof


barnyboy1978
 Share

Recommended Posts

The raised roof section needs to be defined with walls, invisible or not so you can set that area's ceiling height higher than the left and right sections at a lower ceiling height. the little prow roof on the higher roof sections you cannot do in Architectural for that would require Home Designer Pro or above. You may have to get the exact ceiling height for the higher area by trial and error until you get just the right amount of separation.

 

DJP

  • Downvote 1
Link to comment
Share on other sites

monitorroofplan.jpgmonitorroof.jpg

 

This is as far as I have gotten so far following other suggestions from the Roof Tip to just get the roof right with temporary walls that can be deleted after the auto is turned off later.

 

Actually you are wrong I don't need pro.  I followed the info in this earlier thread for the hay hood. https://hometalk.chiefarchitect.com/topic/2473-create-this-barn-roof-with-widow-peak/#comment-13806 I think it works okay in architectural if I can just figure out how to stop the floor.

 

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share