skiguy

I am having problems attaching plan.  Here is another try.

Lake Home 4.plan

Here is the plan.  I had trouble attaching to the initial message.

I am getting some kind of fascia board where a cable roof is betting a 2nd floor wall.  How can I correct this?  I am using HD 2017.

Briefly how did you do that?

Thanks, that is very helpful. 

In one of the training videos when putting a roof plane on a manual dormer the "Set Baseline height"  box with options to put over wall or over roof plane appears.  I don't get that box. 

When creating a manual dormer how do I manage where the roof planes are located?  In the attached plan the roof planes created varied from the top of the dormer wall to the top of the lower roof.

test 2.plan

Here is the plan.

Lake Home 3.plan

I have used several approaches to designing the roof shown in the attached file with little sucess.  I would like to get some advice on how to approach this design.  I am using HD Pro 2016.  I have attached front, rear, and side views.

Front & Rear View.pdf

Side View.pdf

Thanks, that solved my problem.

Thanks for the reply.  Should have looked there.  Here is the image.  Also I am using HD Pro 2016.

test 2.plan

How do I post an image?  I don't have the attachment button.

I am trying to put a roof on top of a dormer.  When I place a roof plane over a manually created dormer wall it ends up attached to the roof below rather than the top of the wall.  What causes this? 

No, I haven't asked him yet.  I will do that.

My architect is using X4 and I have Home Design Pro 2016.  Can I view a file from X4 on my HD 2016 so that I can do camera views, etc?  I have reviewd the Sharing Plans article (KB-00516) but still am not certain.

typo - Obviously I meant gable not cable

How do I manually design a cable line over a window manually.