ZZONNER

Yes, I made the same modification and it works.  The Corrugated Roof material option runs the rib the wrong way.  Glitch in the material default?  Thanks.  

I want to visually show the heat tape supplier and the installer exactly where to put the heat tape.  The heat tape is integral with a 16" metal panel clip that attaches to the major corrugations of the roof panel, to hide the heat tape.  The clip is painted to match the roof panel.  If I do a roof panel aerial view, the panel configurations seem to run the wrong direction.  

SFP-SCH-PBR Shingle Cable Holder Datasheet.pdf

Having an issue getting a roof panel plan showing the metal roof corrugations so I can design a roof tape heating system.  I built the cabin I designed on Home Designer Pro 2019 and its going through its first winter, 12' of snow so far, and the ice dam areas are showing up.  How can I print a layout?

Thanks.  

How do I paint a standard metal roof panel a special color?  I have a paint chip I want to match.  I know how to paint but do not know the RGB Numbers.  I have scanned in the chip into a JPEG.  

That makes sense.  Thanks.  

Guess I figured it out myself, but it's a bit of a work around.  I have to send images of the plan file to Layout and resize them individually.  Kind of a guess on being to scale.  Let me know if there is a more scientific way to do this.  I am sure it will come up again?

I am creating 18"x 24" pdf drawings for permit.  When I place the North Elevation on a layout, then back to the plan, rotate it to show the East Elevation, and move it to the Layout, when I go to Print a PDF, both elevations default to the last one I moved to the Layout.  How can I freeze the North Elevation in the Layout and then move the East Elevation and have them remain?  I need these to scale, so I can't move an Image to the Layout, it's too big?  Is it just a setting?  

How do you scale standard material?  I am using River Rock on my tall fireplace and all the round rock is way too large in Camera View.  I would like it to be 33-50% of the generated size.  Thanks.

I know, brute force is an understatement.  It's my first project with Pro, and it's been a work in process, design / build with the wife.  Should I just delete all the roofs and let them auto build or should I just start over?  I think I can generate good enough plans for permit from what I have but would like it to be better.  Using Deck Plank for Tongue and Groove ceiling has proven to be a challenge at the hips and valley, its direction jumps around.  

Thanks a ton.  You're the best.

In the Orthographic Framing view, the gable wall framing is not showing.  How do I keep some material layers from showing in this view as well?  I also have two small attic wall sections I cannot get to show up.  Any help?  I have attached the file.

Plans_4_Single_Slope_Entry_Slab_for_Contractor_Stairs_MBrm_1.plan